Amada Digipro Manual _top_ Access

: Calibration is required before use. This typically involves pressing the moving square of the protractor to its stop and confirming the value on the NC.

Is your DigiPro unit or does it use a physical tether cable ? amada digipro manual

Two precision-ground straightedges that contact the bent material. : Calibration is required before use

Press brakes are powerful machines that require rigorous safety protocols. The DigiPro manual includes essential safety warnings and risk prevention measures that every operator must understand before using the system. Operators should never attempt to measure parts while

Operators should never attempt to measure parts while the press brake ram is in motion. Always follow the safety protocols outlined in the primary press brake operation manual .

Before its first use (or after a battery change), the DigiPro must be calibrated. The manual specifies placing the unit on a flat, leveled surface to set the "zero" point. This ensures that every measurement taken thereafter is relative to a true horizontal or vertical plane. B. Synchronization with the NC Control